Dolphin walk around boat T Top is designed for. A tow point and navgation light is included, so it has mixed function of boat t top and wakeboard tower. It attaches direct to boat deck, top or side mounted. Removable cover, zipper and velcro.2 inch heavy duty frame. Does not come with any rod holders... Adjustable height up to 63 inches high Up to 108 inches intsallation width 83 inches long x 70 inches wide Cover. 2 inch heavy duty anodised 6063 alloy frame. CNC Machined 6061 Alloy fitting.
Marine grade VIII, UV resist cover. EXPLODED VIEW OF THE DOLPHIN WALK AROUND T TOP FOR REFERENCE.STEP 1: Assemble the front and centre section of the top frame. There are 3 separate pcs in the top frame, connect the lap joints with bolts to joint the 3 pcs to 1 top frame. STEP 2: Attach the Side Supports to the Assemble Top Section. Mark where you want to mount the front legs on your boat, measure the width from the left to right, then putting 2 rubber collars on the front bow, make sure the position is. Mark where you want to mount the rear legs on your boat, note the distance between the front and rear mount is adjustable, the more closer the higher, you can get up to 63in heigt from the mounting level when all 4 legs keep vertical. After get the best position of the rear mounts, measure the width from the left to right, then putting 4 rubber collars on the rear bow, make sure the position is symmetrical. STEP 5: Attach the T top to the floor of the boat.
Place the T Top you have assemble on the marks you have made on your boat. Now you can pre drill and use the bolts and backing plates and lock in you mounting points NOTE: Check under the floor for any wires or objects before drilling holes.
Tips: to give your t top the best strength, please drill through the clamp to the tube using the guide hole on the clamp, and screw the bolt inside the hole, this will stop any shaking during driving the boat, even playing wakeboarding. STEP 6: Attaching the cover to the top frame. Be sure to check and tighten all fastners and connections prior to every use Be cautious when towing or driving under obstacles, low hanging structures or trees Leave dolphin t top in the erect position when towing behind a vehicle Use soap and water to clean your tower. Avoid abraisive material that might scratch or damage the tower protective!Always rinse and wipe down tower after contact with salt (brackish) water. Dolphin T Tops warrants the product (not including other 3rd party accessories) against manufactures defects. To claim you must contact Dolphin T Tops or is Distributor.
The product/part is to be sent to the Distributor for inspection where it will either be repaired or replaced. Dolphin is not responsible for personal injury or damage to the boat caused by the use of the t top or any transport charges or cost of installation or removal of the t top. Dolphin is not liablity for direct or indirect or consequential damages resulting from delay or improper installation. Cally excluded as their care and use can not be controlled by Dolphin.The construction of your boat, design, thickness of ooring deck and walls and overall design may cause movement at the mounting points. If in doubt do not install the t top Check all bolts and parts prior to use, especially after towing behind a vehicle, lowering and raising after storage. Do not stand, climb or jump o# tower, do not tow the boat behind a vehicle with the t top lowered.
Do Not Ski, wake, tow tubes, boats or other watercraft from the tower. Watch out whilst moving under objects, such as bridges, low building and trees. The item "Dolphin t top walk around boat t top potoon bimini t top wakeboard tower fishing" is in sale since Friday, July 10, 2020. This item is in the category "eBay Motors\Parts & Accessories\Boat Parts\Accessories & Gear\Covers".The seller is "make_a_wake_marine" and is located in Azusa, California. This item can be shipped to United States.